Double Bottle Holder Adhesive Mounting Kit 3-Pack

This 3-pack of double-sided adhesive strips are designed for mounting our double-bottle holders, compatible with both the locking and non-locking versions. Each strip measures 5.5" x 4", providing a strong and secure hold. The pack includes 3 alcohol pads to ensure proper surface preparation for both the bottle holders and the wall.

Important Notes:

• To ensure a secure and proper installation, follow these steps carefully. Use the best application (adhesive or screws) suitable for your wall surface. Ensure the tile or marble area is smooth, clean, and dry before beginning. Note: Adhesive mounting strips are not intended for use on drywall.
  
• If you plan to install multiple bottle holders, we recommend testing the adhesive bond with a single holder for several weeks before proceeding with full installation. This ensures the adhesive performs well under your specific conditions.
• Surfaces and wall substrates may vary, so installation methods should be adjusted accordingly.
• Public Goods is not responsible for any installation issues or damages. The purchaser/installer assumes full responsibility for proper installation.
  

Mounting Location:

Choose a location opposite the showerhead to minimize direct water exposure. Position the bottle holder at the desired height (recommended: 40–48 inches from the floor).

Adhesive Mounting:

1. Clean Surfaces Thoroughly:  Wipe the back of the bottle holder and the mounting surface with the rubbing alcohol wipes (isopropyl alcohol) to remove any soap residue or film. Allow both surfaces to dry completely before proceeding.  Important: Skipping this step may result in improper adhesion, causing the fixture to not stick securely.
2. Apply The Double-Sided Mounting Strips:  Remove the protective backing from one side of the strip and press firmly to the clean, dry, back side of the bottle holder.
3. Seal with Silicone:  Apply a thin bead of silicone around the edges of the holder to prevent water from seeping behind it.
4. Secure the Bottle Holder:  Press the bottle holder firmly against the wall for at least one minute. Use a level to ensure it is straight and properly aligned.
5. Allow Silicone to Cure:  Let the silicone dry and cure for at least 12 hours before placing bottles or using the fixture.